Gauges Archive - Cockpit Concept

Thermocouple Board, USB

cpaulus — Thu, 10 Feb 2022 15:56:51 +0000

This board has four analog voltage outputs for controlling instruments that are connected directly to thermocouples. The output voltage can be varied between approx. -4 and 48 mV in 4096 steps.
A data source is selected in the software and connected to the output via a value table.
Thanks to the value table, non-linear thermocouple characteristics can also be calibrated.
The outputs are designed for emulating thermocouples and may only be loaded up to a few mA.

Der Beitrag Thermocouple Board, USB erschien zuerst auf Cockpit Concept.

Resolver Board, USB

cpaulus — Thu, 10 Feb 2022 15:52:37 +0000

This board makes it possible to connect two resolvers to the flight simulator.
If you have any questions, please contact us!

Der Beitrag Resolver Board, USB erschien zuerst auf Cockpit Concept.

Classic Gauges Board, USB

cpaulus — Thu, 10 Feb 2022 15:50:48 +0000

This circuit board has two frequency outputs (50-3500 Hz, 0 to +/- 5 V) and two combined outputs (channel 3/4, 0 to +/- 5 V). The frequency outputs can be used to control 737 Classic N1/N2 instruments, for example. Channels 3 and 4 can be used to control a 737 Classic Fuel Flow Instrument. The output voltage can be set between 0 and +/- 5 V using a trimmer.
A data source is selected in the software and connected to the output via a lookup table. Thanks to the value table, even uneven dials can be calibrated.
The outputs are designed for high-impedance inputs and may only be loaded up to a few mA.

Der Beitrag Classic Gauges Board, USB erschien zuerst auf Cockpit Concept.

Analog Voltage Board, USB

cpaulus — Thu, 10 Feb 2022 15:47:37 +0000

This board has four analog voltage outputs. The output voltage can be adjusted using two trimmers. The range can be changed from 0 to 10 volts, the offset can be set between approx. -11 and +11 volts. This means that numerous combinations are possible, e.g. 0 to 5 V or 6 to 9 V. The voltage range has a resolution of 256 steps. A data source is selected in the software and connected to the output via a lookup table. It can also be used to control original instruments that require an analog voltage. Thanks to the value table, even uneven dials can be calibrated.
The outputs are designed for high-impedance inputs and may only be loaded up to a few mA.

Der Beitrag Analog Voltage Board, USB erschien zuerst auf Cockpit Concept.

Voltmeter Interface, USB

cpaulus — Thu, 10 Feb 2022 15:45:19 +0000

This board makes it possible to connect up to two original voltmeters to the flight simulator via USB. The display can be varied in 4096 steps (12 bits). The software is used to calibrate the displays so that the software and hardware display the same values. Test mode is also supported. Plug and Play for JeeHell FMGS, ProSimA320, FlightFactor A320 and ToLiss A320.

This is a revision of our first voltmeter interface. The required voltage was reduced from 48 to 36 volts and the connection was also changed from a DC connector (5.5 x 2.1 mm) to a terminal. In addition, the resolution has been improved from 8 bits (256 steps) to 12 bits (4096 steps). Calibration is now carried out in the software and no longer by means of a trimmer on the circuit board.

An external 36 volt power supply is required.

Der Beitrag Voltmeter Interface, USB erschien zuerst auf Cockpit Concept.