HS TX AC Backlight, LAN

cpaulus — Thu, 12 Sep 2024 12:33:59 +0000

This board makes it possible to connect original instruments based on the ARINC 429 High Speed Bus to the flight simulator via LAN. The board has a single transmitter unit and has been developed as a LAN version for the “ARINC 429 HS Transmitter, USB”. Instead of selecting a fixed profile as before, you can freely select the data you need and want to send from a list in the software. This means that several devices can be operated in parallel on the board without having to create a new special profile.

The board also has a generator for a 400 Hz alternating voltage, which can be varied between 0 and 5 V (RMS) via the software. The lighting of most devices can be operated with 5 V DC without any problems. However, some devices require an AC control voltage to operate and vary the lighting. These are the APE-5100 clock, the DCDU and the full-format printer (Widebody). Similar to other boards, the data source can be selected and a value table can be created for calibration. A total of three connections are available for the voltage (AC signal and ground).

Please note that the output power is only designed as a control voltage for the above-mentioned devices. The circuit board cannot be used to control incandescent lamps.

An external 5 volt power supply is required.

Der Beitrag HS TX AC Backlight, LAN erschien zuerst auf Cockpit Concept.

ARINC 429 HS Transmitter, USB

cpaulus — Tue, 08 Feb 2022 15:34:48 +0000

This board makes it possible to connect original instruments based on the ARINC 429 high speed bus to the flight simulator via USB. The board has a single transmitter unit.

Der Beitrag ARINC 429 HS Transmitter, USB erschien zuerst auf Cockpit Concept.

clock Archive - Cockpit Concept

HS TX AC Backlight, LAN

ARINC 429 HS Transmitter, USB