RMP Board, LAN

cpaulus — Tue, 08 Feb 2022 15:59:06 +0000

This board makes it possible to connect up to three original A3XX Radio Management Panels (RMP) to the flight simulator via LAN. Plug and Play with JeeHell, ProSimA320, FlightFactor A320 and ToLiss A319/A321.

The RMPs must be interconnected as on the real aircraft. If a third RMP is used, this is not connected directly to the board – as on the real aircraft – but to RMP 1 and 2. Only RMP 1 and 2 are connected directly to the board. The board therefore supports the entire RMP system.

Both COM channels of the RMPs are supported, as well as standby navigation, ACARS (VHF 3) and test mode. Even in the event of simulated faults (e.g. failure of two RMPs), all data can be read out by the remaining RMP.

An external 5 volt power supply is required.

Der Beitrag RMP Board, LAN erschien zuerst auf Cockpit Concept.

ARINC 429 LS Transceiver, USB

cpaulus — Mon, 21 Dec 2020 12:24:43 +0000

This board makes it possible to connect original instruments and devices based on the ARINC 429 low speed bus to the flight simulator via USB. The board has a transmitter and a receiver unit. For example, audio control panels, weather radar control panels, ECAM control panels, rudder trim displays, airspeed indicators, altimeters, VHF or ADF control panels can be controlled. Select your device and the target software in the software, everything else happens automatically.

Der Beitrag ARINC 429 LS Transceiver, USB erschien zuerst auf Cockpit Concept.

radio Archive - Cockpit Concept

RMP Board, LAN

ARINC 429 LS Transceiver, USB