The RMPs must be interconnected as on the real aircraft. If a third RMP is used, this is not connected directly to the board – as on the real aircraft – but to RMP 1 and 2. Only RMP 1 and 2 are connected directly to the board. The board therefore supports the entire RMP system.

Both COM channels of the RMPs are supported, as well as standby navigation, ACARS (VHF 3) and test mode. Even in the event of simulated faults (e.g. failure of two RMPs), all data can be read out by the remaining RMP.

An external 5 volt power supply is required.

Der Beitrag RMP Board, LAN erschien zuerst auf Cockpit Concept.