voltage Archive - Cockpit Concept

Analog Output Board Mini, LAN

cpaulus — Mon, 20 Jan 2025 12:45:44 +0000

The board has 4 analog voltage outputs. The voltage range has a resolution of 12 bits (value 0 to 4095) and can be preset using two trimmers. The voltage range can be changed from 0 to approx. 9.7 volts and an offset between approx. -12.5 and +11.3 volts can be set. This allows the full 12 bits to be used in the preset voltage range. Numerous combinations are possible, e.g. 0 to 5 V or -3 to +3 V. Plug and play with JeeHell, ProSim (A320 and 737) and X-Plane.

A data source is selected in the software and connected to the output via a lookup table. It can also be used to control original instruments that require an analog voltage. Thanks to the value table, even uneven dials can be calibrated.
The outputs are designed for high-impedance inputs and may only be loaded up to a few mA.

The board is a smaller version of the “Analog Output Board, LAN” and has been developed as a LAN version for the “Analog Voltage Board, USB”.

An external 5 volt power supply is required.

Der Beitrag Analog Output Board Mini, LAN erschien zuerst auf Cockpit Concept.

Analog Voltage Board, USB

cpaulus — Thu, 10 Feb 2022 15:47:37 +0000

This board has four analog voltage outputs. The output voltage can be adjusted using two trimmers. The range can be changed from 0 to 10 volts, the offset can be set between approx. -11 and +11 volts. This means that numerous combinations are possible, e.g. 0 to 5 V or 6 to 9 V. The voltage range has a resolution of 256 steps. A data source is selected in the software and connected to the output via a lookup table. It can also be used to control original instruments that require an analog voltage. Thanks to the value table, even uneven dials can be calibrated.
The outputs are designed for high-impedance inputs and may only be loaded up to a few mA.

Der Beitrag Analog Voltage Board, USB erschien zuerst auf Cockpit Concept.

Voltmeter Interface, USB

cpaulus — Thu, 10 Feb 2022 15:45:19 +0000

This board makes it possible to connect up to two original voltmeters to the flight simulator via USB. The display can be varied in 4096 steps (12 bits). The software is used to calibrate the displays so that the software and hardware display the same values. Test mode is also supported. Plug and Play for JeeHell FMGS, ProSimA320, FlightFactor A320 and ToLiss A320.

This is a revision of our first voltmeter interface. The required voltage was reduced from 48 to 36 volts and the connection was also changed from a DC connector (5.5 x 2.1 mm) to a terminal. In addition, the resolution has been improved from 8 bits (256 steps) to 12 bits (4096 steps). Calibration is now carried out in the software and no longer by means of a trimmer on the circuit board.

An external 36 volt power supply is required.

Der Beitrag Voltmeter Interface, USB erschien zuerst auf Cockpit Concept.